View Single Post
  (#8) Old
hddn_agnda hddn_agnda is offline
Junior Member
 
Posts: 8
Join Date: Mar 2009
Default Re: Xbox 360 Wireless Receiver Mod - SUCCESS! - 04-28-2009, 02:21 PM

The wireless receiver itself is mounted such that one end slides underneath the plastic in the center next to the 802.11 card, and on the other end is slid under the lower left bit of plastic that sticks out along the cable routing for the 802.11 antennas. Doing this, the white connector on the 360 receiver is the highest point on the board (note: I did flatten the cable going into said conenctor a bit) and it does come into contact with the access panel and will cause the 360 receiver to flex a very marginal amount. Not enough that I would worry about it though.
Reply With Quote