[markl17]

let me know how to download that and install it

[abdeir]

Okay apparently you need snow leopard butter this copy the contents of the extra/extensions folder to your boot USB's E/E folder (or to hard drive E/E) but after reading there is an extremely low chance this thing will work and I mean 0.001% chance low

[markl17]

but how he got his dell to recognize that it has 3100 inside

[abdeir]

Apparently there is no qe/cl support and since you are using lion you might not be able to change the boot file, both ways try it, it might have lion support but if does work he said yo can switch bet 640 -800 -1024 only what you need is -1366

[markl17]

you have to explain little bit I am a noob when it comes to these driver stuff

[abdeir]

Originally Posted by markl17

you have to explain little bit I am a noob when it comes to these driver stuff

Okay the boot file is a file that contains the boot procedures, it is also the location in which the patches are normally found, but the a boot file that was made to boot and patch SL cannot boot Lion, whilst if this file was made specifically for SL it will not work lion. Second the kext will not enable video acceleration as stated, what you need to do to try this is bootable lion installer( the guide shows how to make one) then replace the boot file in the usb with the one you downloaded, when done, enter the extra folder you downloaded and copy everything in the extensions folder to extension folder found in your usb's extra folder. When done boot from usb you will have multiple selections, select your working lion install and report back.

[markl17]

on kexts.com there is always some sort of development on bootloader no one can make changes to those bootloaders
http://www.osx86.net/view/2187-intel_hd3000_0x116.html wht is this and does it work on duo

[markl17]

by simple luck I got 1336x768 and machine says it is gma3150
but still claims no kext was loaded but also wifi is not present so go figure
also to do all of this works if i boot in verbose otherwise it just boots in the old booring
so I need so explanation becouse I hit the holy grail?????


also under grub when it wants to load my mac with out usb port it craches so I need some help how to get grub to work

any help would be appreciated it is a unix bootloader

[abdeir]

WHAT?! What kext did you use? Any patch? Anything? Can you retrace your steps?

[snipestech]

Stuck at step 3 it reboots and when i click on the link for the lion boot file its dead
can someone direct me to this file and give an example of what i need to do now ,like what the command should look like etc
Tx