[Departingflights]

I am using the NetbookInstaller Method 2: USB Mac Installation via Any Operating System way to install OSX

and the issue i am running into is when i start the install of OSX i get
Panic(cpu 0 caller 0x001a8cd4) Kernal trap at 0x00000000, type 14=page fault registers:

I am using NetbookCD_0.8.3RC3.iso and retail version of 10.5

any thoughts?

[yidakee]

That is the CPU address and does not really give much info on the KP.

You should really take a picture of the screen, unfortunately.

[Departingflights]

ill do that asap

[Departingflights]

Here is the panic screen.

[Departingflights]

bump?

[Dunhamzzz]

Same problem, with netbook cd and usb methods...

[Johnorama]

I had this identical problem... with some help from the users here on my dell mini i got it sorted ... heres what i did

I downloaded DellMiniBoot v8.0.2b1 from mechdrews site, either that or the 8.0.1 version ... I cant remember which exactly as im at work, but both should technically work... (downloaded it from Downloads | OS X | mechdrew)


Following parts of this guide How To: Hackintosh a Dell Mini 9 Into the Ultimate OS X Netbook - Dell mini 9 hackintosh guide - Gizmodo I booted the operating system disk and installed the operating system sucessfully - although it did give me the installation failed message at the end but thats just a false message

Next I booted the OS again and following the guide above instead of booting from the DVD drive (which i think the code was 9f) i booted from the SSD (which i think the code was 80, maybe - check the guide for specifics)

Next step i installed the combo update - which seemed to freeze about 90% - I left it at 90% for around 30 mins then hard reset - booted it up and it said it was running the updated 10.5.8 os version fine

then i used netbook cd to install the drivers etc ...

DONE!