Seemed so easy:
- Run NBI 0.8.3F
- Install 10.6.2 upgrade
- Run NBI 0.8.3F again
Result was a restart loop at the Dell opening screen.
Figuring I should start from scratch with my original install usb, I used F2 to enable legacy USB support, saved and exited. Now all I get is a black screen and not even the Dell BIOS start up. I can find no way to progress beyond this point and even get back to 10.6.1 -- which is where I will stay if I can ever get it back.
Any suggestions on recovery? And where did I go wrong?
---------- Post added at 03:53 PM ---------- Previous post was at 02:46 PM ----------
Well, I've torn my hair over this for a while, and I can find no way to get this thing to boot or show the BIOS screen or the Dell opening screen. Display is dark.
External monitor also shows No Signal. The only change I made was to enable legacy usb support and then it died. Any ideas?
If no good ideas, I figure I now own a brick. But it is just to coincidental that this would happen when it did.